Table of Contents
Advertisement
12
CONNECTION AND PREPARATION
Connecting the power supply unit
Insert the plug of the power supply unit into the
1
socket of the digital receiver.
2
Insert the power supply unit into the wall socket.
Notes:
Do not insert the power supply unit of your device into the socket
until you have connected the television and the antenna.
The only way to fully disconnect the digital receiver from the
mains supply is to pull out the power supply.
Inserting batteries in the remote control
Open the battery compartment by removing the lid.
1
2
When inserting the batteries (for example, R06 or AA,
2 x 1.5 V) observing the polarity marked in the battery com-
partment.
Close the battery compartment.
3
Note:
If the digital receiver no longer reacts properly to remote control
commands, the batteries may be flat. Always remove used bat-
teries.
The manufacturer accepts no liability for damage caused by
leaking batteries.
Environmental note
Batteries, including those which do not contain heavy metal,
should not be disposed of with household waste. Always dispo-
se of used batteries in accordance with local environmental
regulations.
»12
VDC«
Advertisement
Table of Contents
