Table of Contents
Advertisement
10
CONNECTION/PREPARATION
Connecting the infrared receiver
Plug the infrared receiver into the
1
Connecting the power supply unit
Insert the plug of the enclosed power supply unit into the
1
»12
VDC« socket of the digital receiver.
2
Insert the power supply unit into the wall socket.
Notes:
Do not insert the power supply unit of your device into the sock-
et until you have connected the television and the antenna.
The only way to fully disconnect the digital receiver from the
mains supply is to pull out the power supply.
Inserting batteries into the remote control
Open the battery compartment by removing the lid.
1
2
Insert the batteries (AA, 2 x 1.5 V).
Make sure the polarity is correct (as shown on the base of the
battery compartment).
Close the battery compartment.
3
Note:
If the digital receiver no longer reacts properly to remote control
commands, the batteries may be flat. Always remove used bat-
teries.
The manufacturer accepts no liability for damage caused by
leaking batteries.
Environmental note
Batteries, including those which contain no heavy metal, should
not be disposed of with household waste. Please dispose of
used batteries in an environmentally sound manner and in
accordance with the legal regulations that apply in your area.
»IR
remote« socket.
__________
Advertisement
Table of Contents
