Table of Contents
Advertisement
10
CONNECTION/PREPARATION
Connecting the infrared receiver
Insert the plug of the infrared receiver into the
1
socket of the digital receiver.
Connecting the power supply unit
Insert the plug of the power supply unit supplied into the
1
»12
VDC« socket of the digital receiver.
Insert the power supply unit into the wall socket.
2
Notes:
Do not insert the power supply unit of your device into the
socket until you have connected the television and the antenna.
The only way to fully disconnect the digital receiver from the
mains supply is to pull out the power supply.
Inserting batteries in the remote control
1
Open the battery compartment by removing the lid.
Put in the batteries (AA, 2 x 1.5 V). Make sure the polarity is
2
correct (as shown on the base of the battery compartment).
Close the battery compartment.
3
Note:
If the digital receiver no longer reacts properly to remote control
commands, the batteries may be flat. Always remove used
batteries.
The manufacturer accepts no liability for damage caused by
leaking batteries.
Environmental note
Batteries, including those which contain no heavy metal, should
not be disposed of with household waste. Please dispose of
used batteries in an environmentally sound manner. Find out
about the legal regulations which apply in your area.
__________
»IR
remote«
Advertisement
Table of Contents
