Fitting/Using The Tools On Your Food Processor - Sunbeam LC7900 Instruction Booklet

Fitting/Using the tools on your
Food Processor
Note: All attachments must be firmly
attached to the spindle. Always adjust the
attachments until you are sure that they are
correctly fitted.
Placing the spindle
1.Fit the spindle onto the drive shaft,
see figure 4.
Fig 4
Universal 's' Blade
1.Fit the processing bowl and spindle as
detailed previously in figures 1, 2 & 4.
2.Fit the universal 's' blade over the spindle
and press firmly into place, see figure 5.
Warning: Use caution, as blades are sharp.
Always handle the processing blade by its
central plastic section.
Fig 5
3.Place food into the processing bowl.
4.Fit the processing cover to the processing
bowl, see figure 3 and place the food
pusher in the feed chute.
5.Plug the power cord into a 230-240V AC
power outlet and turn the power 'ON'.
6.Start processing using the START/STOP
or Pulse buttons.
7.When processing is complete, remove the
spindle and blade from the processing bowl
before removing the processed food.
9