Table of Contents
Advertisement
Web-Based Management
Port Configuration
Use the Port Configuration menu to configure any port on the switch.
Parameter
Flow control mode
(on all ports)
Admin Status
Speed/Duplex Status
Flow Control Status
Note: Whenever a user adds a port as a trunk member, this port can only be disabled in
the "Port Trunking Configuration" page as part of the entire trunk group.
3-34
Default
Description
Disabled
See "Flow Control Status" in this table.
Enable
Allows you to disable a port due to abnormal behavior, and then
re-enable it after the problem has been resolved. You may also
disable a port for security reasons.
Auto-
Used to set the current port speed, duplex mode, flow control, and
Negotiation
auto-negotiation.
Auto-negotiation is the default setting for 10BASE-T/
100BASE-TX.
Disabled
Used to enable or disable flow control. Flow control can eliminate
frame loss by "blocking" traffic from end stations or segments
connected directly to the switch when its buffers fill. Back
pressure is used for half duplex and IEEE 802.3x for full duplex.
Note that flow control should not be used if a port is connected to
a hub.
Hide quick links:
Advertisement
Table of Contents
