4) If there is no WWVB reception, manually set the time and date (instructions in the Program Mode). 5) Program the settings. 6) Mount the WS-8011UM in a suitable location, where WWVB and transmitter signals can be received. 7) Mount the transmitter where remote temperature measurement is desired (on the North side of a house for example).
through H. Press the “SNOOZE” button at any time to exit the Program Mode, or A) REMOTE TEMPERATURE TRANSMITTER wait approximately 15 seconds for the Temperature Clock to automatically return to 1) Remove the battery cover. Place your thumb over normal operation.
8) The default weekday “MON” (depends on selected language) will flash. D) LANGUAGE SELECTION FOR THE WEEKDAY Press the “+” button to select the appropriate weekday. 9) Press the “SET” button to confirm the calendar settings, and to advance to 1) Hold down the “SET”...
(c) Press the “ALARM” button to confirm the hour, and to set the alarm MOUNTING minutes. Hanging Holes (d) The alarm minutes flash, press the “+” button to set the alarm minutes. (e) Press the “ALARM” button to confirm and to exit the alarm setting mode.
2) Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. Remove the Note: For any questions not answered, contact La Crosse Technology with the contact protective strip from the other side of the tape. Position the Remote information found at the end of this instructional manual.
Page 7
WS-8011UM – TX6U LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, 433 MHz CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS TEMPERATURE CLOCK. Radio Controlled Temperature Clock THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION.
temperature, the date as “1/ 1”, the weekday as “MON”, and the remote temperature will be displayed (within three minutes). Also, the time will appear as “-:--” for The remote temperature sensor should be placed in a dry, shaded area. The remote approximately 1 minute.
Page 10
3) Press and release the “SET” button to confirm the time zone setting, and to Note: when setting the hour, “PM” will appear to the left of the hour display, if advance to DST (Daylight saving time) setting. it is AM nothing will be displayed. C) DST (DAYLIGHT SAVING TIME) SETTING 4) Press and release the “SET”...
H) SELECTING F OR C Note: The alarm will be automatically set to sound when exiting the alarm- 1) Hold down the “SET” button for 2 seconds (the selected time zone will setting mode (indicated by the alarm “sound” icon to the right of the time). flash).
Opening the casings invalidates the warranty. Do not try to repair the units. from the wall. Contact La Crosse Technology for Repairs. 3) Place the temperature clock onto the screws, using the hanging holes on the backside. Gently pull the temperature clock down to lock the screws into TROUBLESHOOTING place.
Ft. Collins, Colorado. 2) Wait overnight for signal. Before sending the temperature clock in for repairs, contact La Crosse Technology. The 3) Be sure the temperature clock is at least 6 feet from any temperature clock will be repaired or replaced with the same or similar model.