Section 4: System Installation; Main Control Panel; Wireless Indoor Lighted Siren - Q-See QSDL503AD User Manual

Section 4: SYSTEM INSTALLATION
4.1:

Main Control Panel

1. Connect one end of the enclosed standard telephone wire to the wire inlet on the Main
Control Panel (See Picture 1) and the other end to the telephone.
2. Plug the jack of enclosed adapter into the DC plug of the Main Control Panel (See
Picture 1) and connect the AC plug into a wall plug or surge protector.
3. Load 4 "AAA" batteries into the back of the Main Control Panel to use as a backup
energy source in the event of a power failure.
4. It is recommended to install the Main Control Panel in a discreet location and out of
clear view of a potential intruder.
5. As depicted in Picture 1, the ON/OFF switch on the left side of the Main Control Panel
allows you to turn the power to your system on or off. When you turn the system on, the
indicator light on the front of the Main Control Panel will emit a red light and you will hear
a single beep indicating that the power is on.
DC Plug
(Side View 1)
(Picture 2)
ON/OFF
Phone
Input
4.2:

Wireless Indoor Lighted Siren

1. Remove the battery compartment cover on the back of the Wireless Indoor
Lighted Siren and insert the enclosed L+ Battery. Replace the battery
compartment cover and mount the Wireless Indoor Lighted Siren in a location
that is elevated and in plain sight.
2. The LED light on the front of the Wireless Indoor Lighted Siren (See Picture 2)
will notify you that the device is powered on by flashing in 5 second intervals.
QSDL503AD USER MANUAL
(Front View)
(Picture 1)
2 | P a g e
Antenna
Input
(Side View 2)