Gigabyte GA-586TX3 User Manual page 98

GA-586TX3
Ö
MEMORY SIZE HAS CHANGED SINCE LAST BOOT
Memory has been added or removed since the last boot. In EISA mode
use Configuration Utility to re-configure the memory configuration.
In ISA mode enter Setup and enter the new memory size in the memory
fields.
Ö
Memory Verify Error at ...
Indicates an error verifying a value already written to memory. Use the
location along with your system's memory map to locate the bad chip.
Ö
OFFENDING ADDRESS NOT FOUND
This message is used in conjunction with the I/O CHANNEL CHECK and
RAM PARITY ERROR messages when the segment that has caused the
problem cannot be isolated.
Ö
OFFENDING SEGMENT:
This message is used in conjunction with the I/O CHANNEL CHECK and
RAM PARITY ERROR messages when the segment that has caused the
problem has been isolated.
Ö
PRESS A KEY TO REBOOT
This will be displayed at the bottom screen when an error occurs that
requires you to reboot. Press any key and the system will reboot.
Ö
PRESS F1 TO DISABLE NMI, F2 TO REBOOT
When BIOS detects a Non-miscible Interrupt condition during boot, this
will allow you to disable the NMI and continue to boot, or you can reboot
the system will the NMI enabled.
Ö
RAM PARITY ERROR - CHECKING FOR SEGMENT ...
Indicates a parity error in Random Access Memory.
Ö
Should Be Empty But ISA Board Found
PLEASE RUN EISA CONFIGURATION UTILITY
A valid board ID was found in a slot that was configured as having no
board ID.
F
When this error appears, the system will boot in ISA mode, which allows
you to run the EISA Configuration Utility.
A-4