Forward-Facing Installation With Latch - Graco COMFORTSPORT ISPC054BA Instruction Manual

FORWARD-FACING
1
LATCH belt must be routed through
opening in child restraint for
(see page 23, fig. l).
Belt must lay flat and not be twisted.
2
Adjust child restraint to upright position
(see pages 18 and 19, fig. b) and place
forward-facing
with LATCH anchors.
3
For ease of installation, extend
to its maximum length.
4
Hook connectors to vehicle lower anchors
(fig. a). Pull connectors to be sure they are
securely attached (fig. b).
5
Press down firmly in center of child restraint to
compress vehicle seat cushion while tightening
LATCH belt by pulling adjustment belt (fig. c).
Use your knee to press down in center of
child restraint (fig. c).
10
INSTALLATION WITH
forward-facing
on vehicle seat equipped
LATCH
6
Pull front to back and left to right to check for
secure installation (fig. d).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service
(see back cover).
Attach tether strap hook (A) to anchor
7
hardware (B) and tighten adjustment belt to
remove any slack (fig. e).
belt
Periodically check that child restraint is securely
installed; adjust if necessary.
LATCH