Denon RCD-M35DAB Operating Instructions Manual page 12

Manual tuning
1 2
Example: Tuning in FM 92.50 MHz
(AM stations are tuned in using the same procedure.)
Press the power operation
1
switch to turn on the power.
Press the FUNCTION or
2 TUNER button to select TUNER
mode.
Press the /BAND button on
2
3 the tuner to select the FM
AUTO.
Use the Tuning +/– (TU+/ TU–) button to tune the
frequency to 92.50. Once the frequency is tuned in,
adjust the volume to the desired level using the VOLUME
control.
4
Main unit
12
3
4
4
4
Main unit Remote control unit
Main unit Remote control unit
Main unit Remote control unit
Remote control unit
The function of the +/– button on the main unit may toggle between Tuning +/– and Preset +/–
functions.
• Pressing the – button while holding down the BAND button at the same time changes function
of the +/– button to Tuning +/–. ("TUNING" flashes for 5 seconds.)
1
• Pressing the + button while holding down the BAND button at the same time changes the
2 function of the +/– button to Preset +/–. ("PRESET" flashes for 5 seconds.)
• The +/– button is factory preset to function as a Tuning +/– button.
However, be sure that the +/- buttons function as the Tuning +/– button before proceeding with
step 4.
Auto Tuning
• When a program being broadcast in stereo is received, the "ST" indicator lights and the
3
program is received in stereo.
• If reception is poor and there is much noise in the stereo signals, press the BAND button to set
the FM MONO mode.
• When one of the Tuning +/– (TU+/ TU–) button is pressed, the frequency changes in steps of 50
kHz in the FM band, 9 kHz in the AM band.
• If one of the Tuning +/– (TU+/ TU–) button is held for over 1 second, the frequency continues to
change when the button is released (auto tuning) and stops when a station is tuned in. Tuning
will not stop at stations whose reception is poor.
• To stop the auto tuning function, press the Tuning +/– (TU+/ TU–) button once.
NOTE:
• A humming sound may be heard when using a TV nearby while receiving AM programs. If
this happens, move the system as far from the TV as possible.