Table of Contents
Advertisement
3
Brown:
5
Blue:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1.
Connect the wire coloured green and
yellow to the terminal marked either
with the letter "E" or by the earth
symbol
or coloured green and yel-
low.
2.
Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3.
Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
7.4 Removing the transport support
4.
Live
Neutral
5.
6.
The appliance is supplied with a 13 amp
plug fitted
change the fuse in the plug supplied, a 13
amp ASTA approved (BS 1362) fuse must
be used.
Your appliance is equipped with transport
support to secure the door during trans-
portation.
To remove them do these steps:
• Open the door.
• Remove the transport support from the
Check that no cut, or stray strands of
wire is present and the cord clamp
is secure over the outer sheath.
Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
Switch on the appliance.
2
. In the event of having to
WARNING!
A cut off plug inserted into a 13
amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
door sides.
Some models are fitted with a si-
lencing pad under the cabinet. Do
not remove this pad.
ENGLISH
15
4
Advertisement
Table of Contents
