Replacing The Dust Bag, S-Bag; Replacement Of The Exhaust Filter - Electrolux ergospace Instruction Manual

Electrolux vacuum cleaner dust magnet + hepa h12 filtration
Hide thumbs Also See for ergospace:
Table of Contents

Advertisement

English

Replacing the dust bag, s-bag

26
Open the front cover and lift out the insert holding the
s-bag
®
.
27
Pull the cardboard to remove the s-bag
This automatically seals the s-bag
leaking out.
28
Insert a new s-bag
®
by pushing the cardboard right into the
end of the groove in the insert.
29
Put the insert back into the bag compartment, and close
the cover.
Note. Replace the s-bag
even if it is not full (it could be
®
obstructed). Also replace after vacuuming carpet-cleaning
powder. Be sure to use only an original Electrolux dust bags,
s-bag
®
Classic, s-bag
®
Clinic Anti-Allergy, s-bag
performance or s-bag
®
Anti-odour.
Replacement of the filter(s)
The more often the better for the efficiency of the cleaner.
In standard household use, the filters should be replaced
approximately every 3 years. Never use the vacuum cleaner
without filter(s).
Open the front cover and lift out the insert holding of s-bag
30
Pull the filter(s) holder upwards until coming away from the
groove. Carefully pull the old, dirty filter(s) out of the filter
holder and replace with a new filter(s).
31
Reattach the filter holder containing the new filter(s). Put
the insert holding of s-bag
back in the cleaner and then
®
close the cover.

Replacement of the exhaust filter

The filters must always be replaced with new ones and cannot
be washed (if not mentioned).
32
Place your thumbs on the back edge of the lid and then
open the lid by pulling the handle backwards and upwards
with your index/middle finger.
33
Lift out the filter. Insert a new filter and replace the lid as
shown.
34
In case of models with washable HEPA filter. Rinse the
inside (dirty side) of the filter unit under warm tap water
only. Do not use cleaning agents and avoid touching the
delicate filter surface. Tap the filter frame to remove excess
water. Repeat cleaning procedure four times and allow the
filter to air dry. The original filtering performance is now
restored. Replace the unit back into the cleaner and close
cover ensuring it is properly fastened.
2193584-02Outline.indd 11
®
®
from the insert.
®
and prevents dust
®
Classic long
®
11
10/17/08 1:58:24 PM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ergospace

Table of Contents