Page 3
한국 4–14 Electrolux Ergospace 진공 청소기를 구입해 주셔서 감사합니 다. 본 사용 설명서는 Ergospace 전 모델에 적용될 수 있습니 다. 따라서, 구입하신 모델에는 일부 부속품 또는 기능이 빠져 있을 수 있습니다. 세부 모델명 및 부속품명은 박스 겉면 라벨 에 표시되어 있습니다. 제품을 최상의 상태로 사용하려면 항상...
• Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. All servicing and repairs must be carried out by an authorised Electrolux service centre. Be sure to keep the vacuum cleaner in a dry place.If the supply cord is damaged, it must be replaced by...
English Before starting Open the front cover on the machine and check that the dust bag, s-bag ® and the motorfilter are in place. (See also Replacement of filter(s)) Open the back lid on the machine and check that the exhaust filter is in place.
English Getting the best results. Accessories on board 3 in 1 multi tool nozzle to be found in the back of the cleaner. Use the nozzles as follows: Carpets: * Use the carpet/hard floor nozzle with lever in position (21). Reduce suction power for small carpets. * On the Dust Magnet nozzle (23 and 24) there is normally no need to switch mode.
Note. Replace the s-bag even if it is not full (it could be ® obstructed). Also replace after vacuuming carpet-cleaning powder. Be sure to use only an original Electrolux dust bags, s-bag ® Classic, s-bag ® Clinic Anti-Allergy, s-bag ®...
English Cleaning the hose and nozzle The vacuum cleaner stops automatically if the nozzle, tube, hose or filters and s-bag ® becomes blocked. In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or replace filters and s-bag® and restart. Tubes and hoses Use a cleaning strip or similar to clear the tubes and hose.
• Are the filters blocked? Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. Consumer information...
Page 16
Share more thinking at www.electrolux.com 2193664-02 2193584-02Outline.indd 16 10/17/08 1:58:44 PM...