Lennox Hearth Products Winslow Installation And Operation Manual page 32

7. Remove the 3 screws located across the top of the pellet hopper (see
Figure 59).
Figure 59
8. Set the assembled ZC box near the back of the stove and pull the
power cord, located in the lower rear of the stove, through the rubber
grommet at the bottom of the back panel (A). Now, pull the wiring
harness through the rubber grommet located towards the bottom
of the right side panel (C) (see Figure 60). Slide the ZC box against
the back of the stove and reinstall the 3 screws removed in Step 7
through top panel (D) and into the stove.
Figure 60
3
9. Install the access panel (E) by screwing it onto the right side panel
(C), using four of the sheet metal screws provided.
Figure 61
10. Final step: Install the 4 door washers (K), using 4 of the sheet metal
screws provided, insert two on each lower side of your ZC box (shown
in the Figure 62). You are now ready to install your PI40 pellet insert.
Follow all vent clearances stated in your Installation and Operation
Manual and the vent manufacturers instructions.
Figure 62
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
C
E
K