Lennox Hearth Products Winslow Installation And Operation Manual page 13

4. Place one washer on each stud. Using a 3/8" nut driver, snug up the
nuts on each piece of trim. Do not finish tightening the nuts yet. See
Figure 19.
5. There should be approximately a 7/8" (22 mm) gap between the top
edge of the upper door trim and the top edge of the front door and
a 1-1/2" (38 mm) gap between the lower door trim to the bottom of
the front door. Visually inspect the alignment of the trim and adjust
if necessary. See Figure 20.
6. Finish tightening nuts. CAUTION - DO NOT OVER-TIGHTEN NUTS,
DIMPLING OF THE TRIM WILL OCCUR!!!
Holes for trim studs
Figure 16
Trim stud
Figure 17
Door Handle
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
9/16"
Figure 18
Figure 19
Figure 20
Top edge of lower door trim
1-1/"
Bottom edge of lower door trim
to bottom edge of front door
13