Table of Contents
Advertisement
Outside Air Installations
Connecting the Winslow PI40 insert to outside combustion air is optional,
except in mobile home installations and when required by local building
codes. The fireplace insert's air intake will accept 2" ID pipe to accommodate
outside air installations. The air intake on the exterior of the home should
always be located substantially below the flue termination and must remain
free of obstruction. The inlet must also have a screen with openings not
larger than 1/4" to prevent rodents from entering. The outside air pipe
may run up the chimney, horizontally, or down provided the structural
integrity of the fireplace and chimney system are maintained.
Thermostat installation
The Winslow PI40 insert can be operated manually or by thermostat.
The insert comes from the factory wired to operate manually, see control
board operation on Page 18. A low voltage thermostat can be installed
on the insert. To install the thermostat:
1. Unplug the insert from the electrical outlet. Open the right side door
and lift out the control board from its retaining brackets. Locate the
light green wiring block at the bottom back of the board (see Figure
13), loosen the two screws B at the back of the block, and remove
the U shaped jumper wire A protruding from the block.
2. Insert a wire from the thermostat into one of the slots from which the
jumper wire was removed. Repeat this process for the other thermostat
wire.
Retain the jumper wire for future reinstallation. See Page 18 for ther-
mostat operation instructions.
IMPORTANT NOTE: Install the thermostat per the manufacturers
instructions, provided with the thermostat. Failure to follow
manufacturers instructions could result in a malfunction. Pay
special attention to the thermostat location requirements. If the
location requirements are not adhered to the appliance, erratic
operation or failure may occur.
Do not mount the thermostat where it may be affected by:
• Radiant heat from the insert, fireplaces, sun or other heat
sources.
• Drafts or dead spots behind doors or in corners.
• Hot or cold air from ducts.
Rear View of Control Board
Rear View of Control Board
Figure 13
1
A = Jumper Wire
B = Screws
Wiring Block
Wiring Block
A
B
A
B
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Door Trim Installation Instructions
Parts List (A)
Qty
(2) Trim Pieces (Black, Gold, Nickel, Brushed Nickel or Black Nickel)
(6) #10 Nuts
(6) #10 Washers
Tools Needed
3/8" Nut Driver or Socket Wrench
A
Trim Pieces
Trim Nuts
Figure 14
IMPORTANT
If you have a gold or nickel trim, be sure to clean
them with a soft cloth and household glass cleaner
prior to burning the insert. Fingerprints left on the
plated surfaces while burning will usually remain
on the finish permanently.
To Install Door Trim:
1. Remove the trim pieces and hardware from its packaging and ensure
that all pieces are present before beginning installation. Take care
not to scratch finished surfaces.
2. Open right and left side door. The side doors swivel open towards
the back of the insert. See Figure 16.
3. Open front door. Put door trim in place by inserting trim studs into
the corresponding holes in the front door (Figures 14 and 15). The
upper door trim will only fit in one direction, but the lower door trim
can be installed incorrectly. When placing the lower door trim, make
sure that the distance between the top edge of the lower door trim to
the glass in the door is 9/16" (see Figure 18).
Pellet Stove Door
Pellet Stove Door
Figure 15
#10 washers
Upper Door Trim
Trim Pieces
Lower Door Trim
Advertisement
Table of Contents
