Planet DVR-460 User Manual page 72

‧ DVR-860
PIN FUNCTION
GND
1
ALARM INPUT
2~9
PIN OFF
10
TXD232
11
RS485-A
12
EXTERNAL
13
ALARM NO.
PIN OFF
14
ALARM INPUT
15~22
RXD232
23
RS485-B
24
GROUND
When connecting the wire from ALARM INPUT (PIN 2 -- 9) to GND (PIN 1)
connector, DVR will start recording and the buzzer will be on.
When "MENU -> ADVANCE -> DETECTION -> DETECTION SETUP -> ALARM" is
set to "Low" : When the alarm input signal is " Low ", the unit starts to record and
buzzer.
When "MENU -> ADVANCE -> DETECTION -> DETECTION SETUP -> ALARM" is
set to "High" : When the alarm input signal is " High ", the unit starts to record and buzzer.
DVR can be controlled remotely by the keyboard of PC by using RS-232 serial communication
signals.
DVR can be controlled remotely by the keyboard of PC by using RS-485 serial communication
signals.
Under the normal operation, COM disconnects with NO. But when any alarm is
triggered, COM connects with NO.
Attention: The voltage restriction is under DC24V 1A.
When connecting the wire from ALARM INPUT (PIN 15 -- 22) to GND (PIN 1) connector, DVR
will start recording and the buzzer will be on.
When "MENU -> ADVANCE -> DETECTION -> DETECTION SETUP -> ALARM" is
set to "Low" : When the alarm input signal is " Low ", the unit starts to record and buzzer.
When "MENU -> ADVANCE -> DETECTION -> DETECTION SETUP -> ALARM" is
set to "High" : When the alarm input signal is " High ", the unit starts to record and buzzer
DVR can be controlled remotely by the keyboard of PC by using RS-232 serial communication
signals.
DVR can be controlled remotely by the keyboard of PC by using RS-485 serial communication
-66-
DESCRIPTION