Appendix 1 Install Hdd - Planet DVR-460 User Manual

4/8-channel mpeg-4 digital video recorder

Hide thumbs Also See for DVR-460:

Table of Contents

APPENDIX 1 INSTALL HDD

◎ HDD Installation

DVR-460

Step 1:

Loosen the screws on the upper cover and open the upper cover of the DVR

Step 2: Screw out the HDD bracket. For the positions of the HDD bracket screws, please refer to the figure below.

Step 3: Get suitable brand HDD and set the HDD mode (master or single).

Step 4: Screw HDD onto the HDD bracket, two screws for each side. And then screw the HDD bracket back to the DVR

base. (Refer to Fig.1 & 2).

Step 5: Connect the HDD to the power connector and IDE BUS (make sure to align the HDD precisely for pin connection)

(Refer to Fig. 3)

Step 6: Close the upper cover of the DVR and fasten all the screws you loosened in the step 1. (Refer to Fig. 4 & 5)

DVR-860

Step 1: Loosen the screws and open the upper cover.

Step 2: When install the first HDD, please set the jumper on the HDD to "Master" mode.

-63-

Table of Contents

Dvr-860