Assembly - ProForm 750 Ekg Bike User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner
screwdriver
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in
the parts bag, check to see if it has been preassembled.
M8 Split Washer
(50)–7
M8 x 25mm Button
Screw (51)–2
1. Attach the Rear Stabiliser (16) to the Frame (1) with
two M10 x 112mm Carriage Bolts (43) and two M10
Nylon Locknuts (63).
.
M8 Nylon Locknut
(65)–4
M10 x 112mm Carriage Bolt (43)–4
M10 Nylon Locknut
(63)–4
M8 x 90mm Button
Screw (41)–1
1
43
16
5
and Phillips
M6 x 8mm
M4 x 16mm
Screw (57)–4 Screw (58)–2
1
63