ProForm 750 Ekg Bike User Manual page 12

Measure your heart rate if desired.
5
If there are
sheets of
clear plastic
on the metal
contacts on
the hand-
grips, peel
off the plas-
tic. To use the
handgrip
pulse sensor, hold the handgrips with your palms
resting against the metal contacts. Avoid moving
your hands. When your pulse is detected, the
heart-shaped indicator in the upper section of the
display will flash each time your heart beats, one
to three dashes will appear, and then your heart
rate will be shown.
For the most accurate heart rate reading, continue
to hold the handgrips for about 30 seconds. Note:
When you first hold the handgrips, the display will
show your heart rate continuously for 30 sec-
onds. The display will then show your heart rate
along with other feedback modes.
Contacts
Turn on the fan if desired.
6
To turn on the
fan at low speed,
press the fan
button. To turn
on the fan at
high speed,
press the fan
button a second
time. To turn off
the fan, press
the fan button a third time. Note: If the fan is
turned on and the pedals are not moved for
about 30 seconds, the fan will turn off to con-
serve the batteries.
Rotate the thumb wheel on the right side of the
console to pivot the fan to the desired angle.
When you are finished exercising, the console
7
will automatically turn off.
If the pedals are not moved for a few seconds,
the displays will pause and the time will flash in
the display.
If the pedals are not moved and the console but-
tons are not pressed for a few minutes, the con-
sole will turn off to conserve the batteries.
EBPE3915
12
Thumb
Wheel
Fan
Button