Reversing The Door - Electrolux WA SL3 M Installation And Maintenance Manual

Installation in warm climates
When installing in temperatures above 25°C
(77°F) with a high level of humidity, do not
route the air exhaust hose upwards.
The hose must always run downwards or stay
level with the tumble dryer.
Condensation problems
If the hose is long and the room is cold, con-
densation will form inside the hose. This is una-
voidable.
If the air exhaust hose is slack, water may
build up at the low points, blocking he air flow.
To avoid water build-up in the hose or that
water runs back into the machine, drill a hole
(Ø3 mm) at the lowest point in the hose and
put a water collector underneath.
Accessories
If the vent hose is ta-
ken to a wall outlet you
can prevent cold air
getting in by fitting a
ventilation grille, artic
le number 9205900.
The ventilation grille
can be installed inside or outside.
MECHANICAL INSTALLATION
Ventila-
tion grille
If there is only one vent duct from the room
then a vent spacer must be fitted, article num-
ber 92 059 01.
Vent spacer

REVERSING THE DOOR

The dryer is supplied with the door hinged on
the left side. You can reverse the door so that
the hinge is on the right side
Do as follows:
1. Remove the lower front panel and unscrew
the three screws that hold the door hinge brack-
et.
Door hinge
bracket
TUMBLE DRYER
2 3