Reversing Door - Electrolux 300 SERIES Installation Instructions Manual

12 Reversing Door

Door reversibility is available only on 500, or 600 series models.
BEFORE YOU REVERSE WASHER DOOR:
1. Be sure you have adequate swing area
before reversing door.
2. Gather your tools - including a screw driver
with a #2 square bit and plastic knife (or small,
flat prying tool that won't damage paint).
3. Protect flat work surface, such as top of
washer or floor near washer, with a soft
cloth or towel.
4. Be sure washer is unplugged from power
source!
Failure to disconnect power source before servicing could result in personal injury or
even death.
Removing Door Assembly
1. Completely open the door to expose all
four hinge screws.
2. Remove all four hinge screws with #2
square bit driver. Save for reinstalling later.
x4
Fine Thread
3. Hold the door with one hand sup-
porting the handle area and one hand
supporting the hinge. While supporting
the door at the hinge, press firmly with
the other hand until the locating pins
on the back of the hinge plate dislocate
from the front panel.
NOTE
IMPORTANT
WARNING
ELECTRICAL SHOCK HAZARD
Tools needed for reversal:
4. While supporting the door with one
hand, pinch the tabs to release the plas-
tic terminal cap from the hinge plate.
IMPORTANT
Take care not to pull the door away from
the washer until you remove the wiring
harness terminal cap.
5. Set the door face down on a flat sur-
face protected by soft cloth or towel.
Screwdriver
with #2
square bit
Plastic knife