Troubleshooting - Electrolux EWF 106210 A User Manual

14 electrolux
1. Put 2 litres of water in the main wash
compartment of the detergent dispens-
er.
2. Start the programme to drain the wa-
ter.
Frost precautions
If the appliance is installed in an area where
the temperature can be less than 0 °C, re-
move the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.

TROUBLESHOOTING

The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
Problem
The appliance does not
start.
The appliance does not
fill with water.
The appliance does not
drain the water.
Possible cause
The mains plug is not connec-
ted in the mains socket.
The fuse in the box fuse is
damage.
The appliance door is open.
You do not press the start but-
ton
The programme knob is not in
the correct position.
The delay start is set.
It is available only for models
with the Delay start.
The water tap is closed.
The water inlet hose is dam-
aged.
The filter in the water inlet
hose is blocked .
The water tap is blocked or
there is limescale on it.
The connection of the water
inlet hose is not correct.
The water pressure is too low.
The water drain hose is dam-
aged.
The filter of the drain pump is
blocked.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5. Empty the drain pump. Refer to the
emergency drain procedure
6. When the drain pump is empty, install
the inlet hose again.
Warning! Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
Warning! Deactivate the appliance
before you do the checks.
Possible solution
Put in the mains plug.
Replace the fuse.
Close the door firmly.
Press the start button.
Turn the programme knob in the correct
position.
To start immediately the programme,
cancel the delay start.
Open the water tap.
Make sure that the water inlet hose has
no damages.
Clean the filter. Refer to 'Care and clean-
ing'.
Clean the water tap.
Make sure that the connection is cor-
rect.
Contact your local water authority.
Make sure that the water drain hose has
no damages.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.