Tunturi BIKE 1.0 Owner's Manual page 6

ENGLISH
ASSEMBLY
Start by unpacking the equipment and check that you
have the following parts:
1. Frame
2. Rear and front support
3. Pedals (2 pcs)
4. Handlebar
5. Console
6. Assembly kit (contents marked with in the spare part
list): keep the assembly tools, as you may need them e.g.
for adjusting the equipment.
If necessary, please contact your dealer with the model,
equipment serial no. and spare part no. of the missing
part. You'll find a spare part list at the back of this guide.
The packaging includes a silicate bag for absorbing
moisture during storage and transportation. Please dispose
of the bag once you have unpacked the equipment. The
directions left, right, front and back are defined as seen
from the exercising position. We recommend that the
equipment is installed by two adults.
REAR AND FRONT SUPPORT
By holding on to the seat, incline the equipment
backwards so that it rests on its transportation wheels.
Attach the rear support from below with four hexagonal
socket head screws and washers. Attach the front support
to the frame with four screws and washers. Restore the
equipment to its upward position so that it rests on the
support feet.
PEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to the
right pedal crank turning clockwise and the left pedal to
the left pedal crank turning counterclockwise. Fasten the
pedal bands first into the retainerat the device. Thread the
band through the pedal loop and push the band opening
into the projection in the pedal. Fasten the pedal bands
to the pedal outside. Push the band through the locking
buckle and the band locks automatically. The length of
the band can be adjusted with the locking buckle.
34