Scanning Receivable Stations (Scan); Setting The Scanning Time; Storing Stations - Blaupunkt BREMEN MP76 Operating And Installation Manual

Radio mode
Note:
If you call up the radio function menu in
the MW or LW radio mode, the softkey
with the display label "SENS" is on the
fi rst page.
u Press the softkey 5 with the display
label "SENS".
Press the softkey 5 with the display
u
label "FM" or "AM" to set the sensitivity
for "FM" or "AM".
Move the joystick 8 up or right or
u
down or left to set the sensitivity.
You can adjust the sensitivity in increments
from 1 to 6. "Sensitivity 1" is the lowest,
"Sensitivity 6" the highest sensitivity for
very remote stations.
u Press the OK joystick 8 or the MENU
button 9 to exit the menu.
The settings are saved.
Scanning receivable stations
(SCAN)
You can use the scan function to play all the
receivable stations briefl y. You can set the
scanning time in the menu to between 5
and 30 seconds.
Starting SCAN
u
Press and hold down the OK joystick
8 for longer than two seconds.
Scanning begins. "SCAN" appears briefl y
on the display followed by a fl ashing display
of the current station name or the frequen-
cy of the station.
20
Cancelling SCAN and continuing
listening to a station
u Press the OK joystick 8.
Scanning stops and the radio continues
playing the station that it tuned into last.

Setting the scanning time

u Press the MENU button 9.
Press the softkey 5 with the display
u
label "VARIOUS".
u Press the softkey 5 with the display
label "SCANTIME".
Move the joystick 8 up or right or
u
down or left to set the scan time.
u Press the OK joystick 8 or the MENU
button 9 to exit the menu.
The settings are saved.
Note:
The defi ned scanning time is also ap-
plied by the system to scanning carried
out in CD/MP3 and CD-changer mode.

Storing stations

Storing stations manually
u
Select the desired FM memory bank
(FM1, FM2, FM3, FMT) or one of the
wavebands (MW, LW or SW).
u
Tune into the desired station as de-
scribed under "Tuning into a station".
u
Press and hold down one of the six
softkeys for longer than two seconds to
which you want to assign the station.