Recording Traffi C Announcements; Setting The Timer - Blaupunkt BREMEN MP76 Operating And Installation Manual

station name/frequency appears in the top
line of the display and the time of the re-
cording below it. After the fi rst message, all
additional messages are played in ascend-
ing order.
If no messages are recorded, "NO TIM
AVAILABLE" briefl y appears on the display.
After the last message, the system switches
back to the previous operating mode.
If you want to return to the radio mode with-
out fi rst listening to all messages,
press the TUNER button = or the OK
u
joystick 8.
Selecting the TIM message
"TIM" and the number of the message ap-
pear next to the top two softkeys on both
sides of the display.
If you want to listen to one of the displayed
messages without playing the other mes-
sages:
u Press the softkey 5 with the corre-
sponding display label "TIM1", "TIM2",
"TIM3" or "TIM4".
Recording traffi c
announcements
If the device is switched on, traffi c an-
nouncements are automatically recorded
if a traffi c information station is received
and the priority for traffi c announcements
is switched on.
If you are listening to a station that does
not broadcast traffi c information and you
switch off the device while the TIM function
is switched on, the device automatically
searches for a traffi c information station.
TIM – Traffi c Information Memory

Setting the timer

If TIM is switched off, the traffi c announce-
ments of a set traffi c information station
are recorded for 2 hours after switching off
the device. In addition, you can set two tim-
ers that record all traffi c announcements
30 minutes before and 90 minutes after the
adjusted time. The timer is based on the
system time. How to set the system time is
described in the chapter "Clock - Time".
To adjust one of the timers,
u
in radio mode, hold the TUNER button
= pressed for longer than two sec-
onds.
The TIMPLAY menu is displayed.
u Press the NEXT button 4.
The TIMSET menu again.
u Press the softkey 5 with the display
label "TIMER1" for the fi rst timer or
"TIMER2" for the second timer.
The display shows the adjusted time, the
hours are fl ashing.
u Move the joystick 8 up or down and
adjust the hour.
u Move the joystick 8 right and change
the entry position.
The minutes fl ash.
u Move the joystick 8 up or down and
adjust the minutes.
To save the settings,
u press the TUNER button = or the OK
joystick 8.
The settings are saved.
25