Locations Of Controls - Goldstar LWC061JGMK1 Service Manual

1.5 LOCATIONS OF CONTROLS

1.5.1
CONTROLS
Dry Fan
Cool
TEMPERATURE SETTING
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60 F(16 C) to 86 F(30 C) by 1 F(1 C).
Select the lower number for lower temperature of the room.
ENERGY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
FAN/COOL/DRY
• Everytime you push this button, it will toggle between
COOL, FAN and DRY.
ON/OFF TIMER
- STOPPING OPERATION
• Everytime you push this button, when the unit is operating,
timer is set as follows.
(1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours Cancel)
• The Setting Temperature will be raised by 2 F(1 C) 30min. later
and by 2 F(1 C) after another 30 min.
- STARTING OPERATION
• Everytime you push this button, when the unit is
not operating, timer is set as follow.
(1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours Cancel)
POWER
• To turn the unit ON, push the button. To turn the unit OFF,
push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is on the High cool mode
and the temp. at 72 F(22 C).
FAN SPEED
• Everytime you push this button it is set as follows.
{High(F2) Low(F1) High(F2)...}.
—4—