Maintenance - Ryobi ETS-1526AL Owner's Operation Manual

When bevel ripping material of 6" (150mm) or
narrower, use only the push stick(16) to feed
Fasten your dust collector to the back side of
the table to the dust port(22) (Fig. 21).
The dust efficiency measurement is 45%.
WARNING!
The dust from some types of wood can
be harmful.
Do not make any adjustment while the motor
is in motion. Always make sure the machines
plug has been removed from the mains power
source before changing brushes, lubricating
or when doing any works or maintenance
on the machine. After each use, check your
machine for damage or broken parts and
keep it in top working condition by repairing
MOUNT THE TABLE SAW TO THE STAND (FIG. 22&23)
Turn stand(21) upright as shown.
Insert the cross head screws, spring
washers and flat washer to assemble the
four legs and cross braces first. (Fig. 23)
leave all bolts finger tight - do not fully
tighten until assembly is complete.
Remove the lower extension table brace
bolts Carefully place table saw on top of
stand. Align holes in the table saw base
with holes in stand (Fig. 23).
Fully tighten all bolts to the stand before
operation.
MOUNT THE JIGSAW MOUNTING PLATE TO THE TABLE SAW (FIG. 24)
For details, please refer to the Manual of
MOUNT THE ROUTER MOUNTING PLATE TO THE TABLE SAW (FIG 25)
For details, please refer to the Manual of
BEVEL RIPPING (FIG. 20)
DUST COLLECTION (FIG. 21)

MAINTENANCE

Page 7
the workpiece past the saw blade.
For instance, beech and oak dusts are
especially detrimental to health and therefore
may be worked only with dust collector.
or replacing parts immediately. Clean out
accumulated dust. To assure safety and
reliability, all repairs with the exception of
externally accessible brushes should be
performed by an AUTHORISED SERVICE
CENTRE. Faults in the machine, including
guards or saw blades, should be reported as
soon as they are discovered.
WARNING!
The stand consists of 4 holes for mounting
to the ground. Always ensure your table
saw with stand is securely mounted to
the ground. If however, you have decided
not to mount your table saw onto the
stand, please refer to the 4 holes on
the table saw and mount the unit to the
workbench. Always ensure the table saw
is mounted securely either to the stand or
the workbench. Failure to do so, will cause
serious personal injury.
HBT250/139 Jigsaw Mounting Plate.
HBT250/NCF Router Mounting Kit.