Ryobi ETS-1526AL Owner's Operation Manual page 11

ADJUSTMENT OF SAW BLADE (FIG. 8, 9&10)
WARNING:
• Do not use saw blades which are
damaged or deformed.
• Use only saw blades recommended by
the manufacturer.
• Take care that the selection of the saw
blade depends on the material to be cut.
The Blade(15) has been adjusted at the
factory, use a square to check that the blade
o
is at a 90 angle to the table (Fig.8)
When the machine is connected with the
power supply, the live indicator (4) will glow.
OPERATION ON/OFF MAGNETIC SWITCH (FIG. 11)
The magnetic switch (2) is a safety feature of
the machine. Should the supply be interrupted
the switch will automatically default to the
"OFF" position preventing a dangerous
unexpected startup of the machine when the
supply is restored.
Your table saw features an overload reset
button(14). In the event that your saw turns off
during operation, turn the saw off and allow
the motor to cool down for approximately
3 minutes. Push the reset button(14) and
attempt to turn the saw on again. If the saw
does not turn on, turn the switch off and
Elevating handle (13) is used to raise and
lower the blade. Turn it clockwise to lower and
counterclockwise to raise it.
Live Indicator (FIG. 11)
OVERLOAD RESET BUTTON (FIG. 11)
ELEVATING HANDLE (FIG. 12)
If adjustment is needed turn the tilting lock
nut (while holding the adjustment in position)
to fix the adjustment.
Then loosen the indicator fixing screw, set the
indicator of the scale(12) on the " 0
then tighten the fixing screw(Fig.9)
After the 90
adjusted turn the tilting handle to the 45
(Fig.10) side and adjust the 45
Turn the adjustment nut so that the blade is
o
on the 45 position and then tighten the lock
nut.
If not, please check if the power plug is well
connected.
Press the 'ON'
Press the 'OFF' button to stop the machine.
WARNING: Before turning the machine
ON, make sure the blade guard is correctly
installed and operating properly.
check all cords for proper connection and
retry. If it turns on and then cuts off while you
are working, you may be trying to feed the
workpiece too quickly or may be operating
with a dull blade or may be trying to operate
on an insufficient voltage.
Please note - this handle will move sideways
as the tilt or bevel is adjusted.
Page 5
o
setting of the blade has been
o
button to start the machine.
I
O
o " marked
o
angle.