To Verify Connection Configurations - ActionTec GT784WN User Manual

To verify connection configurations:

Windows 7 and Windows Vista:
1. Select the Start Circle, then in the Start Search field, type "ncpa.cpl".
2. Right-click Local Area Connection and click Properties.
3. Highlight (do not uncheck) Internet Protocol TCP/IP Version 4.
4. From the dropdown list, select Properties.
5. Make sure to Obtain IP Address Automatically and Obtain DNS Server Addresses Automatically are
selected, and then click OK.
6. Click Close.
Windows XP:
1. Select Start, then Run.
2. Type "ncpa.cpl" in the Run box.
3. Right-click Local Area Connection, then select Properties.
4. Highlight (do not uncheck) Internet Protocol TCP/IP.
5. Select Properties.
6. Make certain Obtain IP Address Automatically and Obtain DNS Server Addresses Automatically
are selected, and then click OK.
7. Click Close.
Mac OS X:
1. Select the Apple menu, then select System Preferences.
2. Select Network.
3. On the Show dropdown box, select Built-In Ethernet.
4. On the TCP/IP tab, make sure the Configure IPv4 dropdown menu is set to Using DHCP.
5. Click Close.
6. When asked if you want to apply configuration changes, select Apply.
Mac OS 8/9:
1. Select the Apple menu, then select Control Panels, and select TCP/IP.
2. On the Connect via dropdown menu, select Ethernet.
3. On the Configure dropdown menu, select Using DHCP Server.
4. Click Close.
5. When asked if you want to save changes to the configuration, select Save.
1-888-850-5915
Technical Support
Actiontec GT784WN Router
Setup and User Guide
128429/7-12/7670
2