ActionTec GT784WN User Manual page 9

Mac OS X:
1. Select the Apple menu, then select System Preferences.
2. Select Network.
3. On the Show dropdown box, select Built-In Ethernet.
4. On the TCP/IP tab, make certain the Configure IPv4 dropdown box is set to Manually.
5. Using the information from your Customer Information Sheet, set the following:
• IP Address:
• Subnet Mask:
• Default Gateway:
• DNS Servers:
6. When asked if you want to apply configuration changes, select Apply.
Mac OS 8/9:
1. Select the Apple menu, then select Control Panels, and select TCP/IP.
2. On the Connect via dropdown box, select Ethernet.
3. On the Configure dropdown box, select Manually.
4. Using the information from your Customer Information Sheet, set the following:
• IP Address:
• Subnet Mask:
•
Router Address:
• Name Server Addr.:
5. Click Close.
6. When asked if you want to save changes to the configuration, select Save.
After configuring your computer, reboot your router by turning it off and then back on. Finally, open a browser
and verify that you can access the Internet. If you cannot, please contact our Internet Technical Support team.
1-888-850-5915
Technical Support
Actiontec GT784WN Router
One of the LAN Usable IPs
LAN Subnet Mask
LAN Default Gateway
DNS Primary & Secondary Servers
Any one of the LAN Usable IPs
LAN Subnet Mask
LAN Default Gateway.
DNS Primary & Secondary Servers
Setup and User Guide
128429/7-12/7670
8