Jet Module Cartridge And Trim Installation - Delta Jetted Shower Installation Instructions Manual

18 Series Installation - Separate Units
Jetted Shower XO
1
A.
1
Turn off water supplies. Remove
plasterguard (1), test caps (2), bonnet nut
and test cap (3) from the body.
C.
1
Thread trim sleeve (1) onto threaded sleeve (2).
Tighten securely with wrench.

Jet Module Cartridge and Trim Installation

®
2
3
2
B.
2
4
Install cartridge (1) into body (2). Slide
sleeve (3) over cartridge stem and onto body.
Secure with bonnet (4). Ensure bonnet is
tightened securely.
D.
2
Place the oval escutcheon (1) over the jet
body module. Thread the jet sleeve
assemblies (2) onto the jet body module. Use
wrench (3) to tighten the sleeve assemblies.
CAUTION: DO NOT OVERTIGHTEN.
TIGHTEN UNTIL THE ESCUTCHEON IS
FLAT AGAINST THE WALL.
4
1
3
1
2
3
2