Cw Identifier Setup - Yaesu VX-5R Operating Manual

ARTS ( A

CW Identifier Setup

The ARTS feature includes a CW identifier, as discussed previously. Every ten minutes
during ARTS operation, the radio can be instructed to send "DE (your callsign) K" if this
feature is enabled. The callsign field may contain up to 8 characters.
Here's how to program the CW Identifier:
•
Press the [ F/W ] key, then press the [ BAND ( SET ) AR ] key, to enter the Set mode.
‚
Rotate the DIAL to select Menu #33 ("
ƒ
Press the [ BAND ( SET ) AR ] key to enable changing of this Menu item.
„
Rotate the DIAL to set the CW ID function ON.
...
Press the [ BAND ( SET ) AR ] key once more to begin entry of the letters and numbers
in your callsign.
†
Rotate the DIAL to select the first letter or number in your callsign. When the correct
character has been selected, press the [ BAND ( SET ) AR ] key to move on to the next
character.
‡ †
Repeat step
[ BAND ( SET ) AR ] between each entry. Note that the "slant bar" (– • • – • ) is among
the available characters, should you be a "portable" station.
ˆ
To check the programming, before you exit, press the [ F/W ] key momentarily. You
will hear the CW Identification message as you have programmed it.
‰
When you have entered your entire callsign, press the PTT key to save the settings and
exit to normal operation.
Note that the "DE" ( – – – – – • • • ) preceding your callsign is already programmed;
you only need to program your callsign, and the "DE" will be appended at
the time of transmission.
VX-5R O
PERATING
R
UTOMATIC ANGE
as many times as necessary to complete your callsign, pressing
M
ANUAL
Advanced Operation
T
RANSPONDER
CW ID CW ID
CW ID CW ID CW ID
").
)
S
YSTEM
41