Yaesu VX-5R Operating Manual page 64

Set Mode
Set Item 4
Function: ICON selection.
Recall Menu Item 3, then press the [ BAND ( SET ) AR ] key momentarily.
Turn the DIAL to select the desired band or mode on which you wish to utilize an
Icon, then press the [ BAND ( SET ) AR ] key momentarily.
Turn the DIAL to select the desired Icon to be displayed in place of the regular indica-
tor.
Press the PTT key momentarily to save the your new setting and exit to normal opera-
tion.
Set Item 5
Function: Select or disable the VFO Band edge for the current band.
Available Values: ALL/BAND
Default: BAND
ALL: When the VFO frequency reaches the high edge of the current band, the VFO
frequency will jump to the low band edge of the next band (or vice versa).
BAND: When the VFO frequency reaches the high band edge of the current band, the
VFO frequency will jump to the low band edge of the current band (or vice versa).
Set Item 6
Function: Enable/disable the Automatic Repeater Shift function.
Available Values: ON/OFF
Default: ON
Set Item 7
Function: Set the Repeater Shift Direction
Available Values: –RPT/+RPT/SIMP
Default: Depends on the transceiver version.
Set Item 8
Function: Set the magnitude of the Repeater Shift.
Available Values: 0.00 ~ 99.95 MHz
Default: Depends on the transceiver version, as well as the setting of Menu #06 (ARS).
Set Item 9
Function: Enable/disable "VFO Split" Operation
Available Values: ON/OFF
Default: OFF
When this feature "ON," you can operate in a "split" mode between the Main and Sub
VFO frequencies (the Main VFO will be used for Rx, while the Sub VFO will be used for
Tx).
62 VX-5R O
PERATING
M
ANUAL