Amana AKGD3050 Series Owner's Manual page 15

4. Slide cartridge towards rear of cooktop until
cartridge engages cooktop. Lower front of cartridge
into well.
5. Place burner caps on burner base.
A
B
A—Burner Grate
B—Burner Bowl
C—Burner Cap
D—Burner Base
Place Burner Caps and Grate
C
D
15
To make sure cap is properly aligned and leveled,
move burner cap around on burner base. Pegs in the
burner base fit into recess in underside of burner cap.
Burner cap must be correctly seated on burner base for
proper operation of burner.
Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap
is placed on burner base.
Not centered
Position Burner Caps
6. Ignite burner. Properly adjusted burner flames are
clean and blue with a distinct inner cone
approximately ½ inch long.
• If burner flame is blowing or noisy, or if burner
flame is yellow and does not hold its shape, see
"Adjusting Burner Flame Characteristics" section.
7. Replace burner grate when flame is properly
adjusted.
Correct
Too small
Too large