Radio Shack 20-162 User Manual page 47

Notes:
• You can scan only one type of trunked
frequency, either EDACS (GE/Ericsson),
Motorola, LTR (EF Johnson), or EDCAS SCAT
in a bank at one time. You can, however, mix
conventional channels and frequencies in a
bank.
• If you are programming trunked frequencies
for Motorola Type I and hybrid systems, you
must first program the fleet map (see "Type I
and Hybrid Trunked Systems" on p. 62).
• If you are programming frequencies for an
EDACS system you must store them in the
Logical Channel Number order (usually listed
as LCN#). For example, LCN1 would go into
channel 01 for the current bank, and LCN2
would go into channel 02.
• If you are programming frequencies for an
LTR system you must store them in the home
repeater order. For example, home repeater
order 1 would go into channel 01 for the
current bank, and home repeater order 2
would go into channel 02
Follow these steps to program trunked
frequencies:
1. From Scan or Manual Mode, press ENT/PGM
to put the scanner in Programming Mode.
2. Press FUNC +
down or
selection faster.
3. Press or
down or
selection faster.
4. Press TRUNK/MODE to enter the Trunk ID
Programming Mode.
Trunk Scanning
or to select a bank. Hold
to move through the bank
to select a channel. Hold
to move through the channel
47