Grandstream Networks HT701 User Manual page 39

Disable Call Waiting
Disable Call-Waiting
Caller ID
Disable Call Waiting
Tone
Disable Receiver
Offhook Tone
Disable Reminder Ring
for On-Hold Call
Disable Visual MWI
Ring Timeout
Hunting Group Ring
Timeout
Hunting Group Type
Delayed Call Forward
Wait Time
No Key Entry Timeout
Early Dial
FIRMWARE VERSION 1.0.3.1
Ring Cadence located under Advanced Settings Configuration page.
Note: If server supports Alert-Info header and standard ring tone set (Bellcore) or
distinctive ring tone 1-10 is specified, then the ring tone in the Alert-Info header from
server will be used. Bellcore rings and tones are independent from custom ring tones.
The custom ring tones can also be specified by alert-info header, for example
Alert-Info: <http://127.0.0.1>;info=ring5
Default is No. If set to YES Call Waiting indication information will not be provided to
analog phone connected to this FXS port.
Default is No. If set to YES Call Waiting caller ID will not be provided to analog phone
connected to this FXS port.
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting
information arrives. The CWCID information will still be displayed.
Default is No. If set to yes, it will disable the warning to alert that the phone has been
left off-hook for an extended period of time.
Default is No. Do not play the reminder ring when this is set to Yes.
Default is No. If set to "Yes", the MWI information will not be transferred to the analog
phone connected to the FXS port.
Default value is 60 Sec. Incoming call will stop ringing when not picked up given a
specific period of time.
Default value is 20 Sec. If call is not answered within this designated time period, the
callwill be forwarded to the next member of a Hunt Group. HT704 only
Linear and Circular. Default is Circular. Linear style will sort the call to the lowest-
numbered available line, this is also called "serial hunting". Circular style will distribute
the calls "round-robin". If a call is assigned to line 1, the next call goes to 2 and the next
to 3. The succession throughout each of the lines continues even if one of the previous
lines becomes available. When the end of the hunt group is reached, the hunting starts
over at the firstline. Lines are skipped if they are still busy on a previous call. HT704
only
Default value is 20 seconds. In case this feature activated using * codes (*92 code),
the call will be forwarded after this preconfigured amount of time.
Default is 4 seconds. Dialing process is completed and outgoing call is initiated if no
key entry occurs during this preconfigured interval.
Default is No. Use only if proxy supports 484 response. This parameter controls
whether the phone will send an early INVITE each time a key is pressed when a user
dials a number. If set to "Yes", an INVITE is sent using the dial-number collected thus
far; Otherwise, no INVITE is sent until the "(Re-)Dial" button is pressed or after about 5
HT70X USER MANUAL Page 39 of 52