Table of Contents
Advertisement
Integrated Peripherals
UART Mode Select
Standard
HPSIR
ASKIR
•
-
Standard
default setting.
•
-
HPSIR
system via IrDA connector (refer to section 2.3 "Connectors").
setting allows infrared serial communication at a maximum baud rate of
115K baud.
•
-
ASKIR
connector (refer to section 2.3 "Connectors"). This setting allows infrared
serial communication at a maximum baud rate of 19.2K baud.
Integrated Peripherals
RxD, TxD Active
Hi, Hi
Hi, Lo,
Lo, Hi
Lo, Lo
Integrated Peripherals
IR Transmission
Delay
Enabled
Disabled
UART Mode Select
This item is configurable only if the "Onboard UART
2" is enabled. This allows you to specify the mode
of serial port2. The available mode selections are:
Sets serial port 2 to operate in normal mode. This is the
Select this setting if you installed an Infrared module in your
Select this setting if you installed an Infrared module via IrDA
RxD, TxD Active
This item is used to select RxD (Receive Data) and
TxD (Transmit Data) mode for UART, for instance, IR
device, modem, etc. Normally, we suggest you keep
the default setting. Please see the documentation
that comes with your device.
IR Transmission Delay
If Enabled is selected, there will be a 4 characters
delay when SIR is changed from TX mode to RX
mode.
AWARD BIOS
This
4-35
Advertisement
Table of Contents
