AOpen MX3ZA User Manual page 93

AWARD BIOS
Power Management
AC PWR Auto
Recovey
Former-Sts
On
Off
Integrated Peripherals
Onboard FDC
Controller
Enabled
Disabled
Integrated Peripherals
Integrated Peripherals
Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
4-34
AC PWR Auto Recovery
A traditional ATX system should remain at power off
stage when AC power resumes from power failure.
This design is inconvenient for a network server or
workstation, without an UPS, that needs to keep
power-on. This item is used to solve this problem.
Selecting On lets the system can automatically
power-on after AC power resumes; in the other hand,
the system will power-off if you select Off. If Former-
Sts option is selected, the system will power-on or
power-off based on the original state.
Onboard FDC Controller
Setting this parameter to Enabled allows you to
connect your floppy disk drives to the onboard floppy
disk connector instead of a separate controller card.
Change the setting to Disabled if you want to use a
separate controller card.
Onboard Serial Port 1
Onboard Serial Port 2
This item allow you to assign address and interrupt
for the board serial port. Default is Auto.
Note: If you are using a network card, make
sure that the interrupt does not conflict.