Table of Contents
Advertisement
Software Installation
6. NT will prompt you for the correct path, enter D:\Mx3za\Agp\Win9x. (If D is
not your CDROM drive, substitute D with the correct drive letter.)
7. A list of ATI graphics accelerators will be displayed. Select the one you are
using, then click on the "OK" button.
8. Windows NT will once again prompt for confirmation. All appropriate files
are then copied to the hard disk.
9. Restart Windows NT. Windows NT will start up using the mach64 drivers.
10. NT will boot into a default mode and start the Display applet allowing for
mode selection.
Note: If you select a color depth or resolution not supported by the onboard
AGP, NT will substitute 640x480 in 256 colors for the display.
3-8
Caution: You need to setup Windows NT 4.0
Service Pack 3 for installing an AGP card.
Advertisement
Table of Contents
