Side Burner Hose Quick-Connect Assembly - Jenn-Air 720-0164 Instructions Manual

SIDE BURNER HOSE QUICK-CONNECT ASSEMBLY

Estimated Assembly Time: Approximately 5 minutes
No Tools Required
1. Insert the side burner hose with female sleeve through side panel of cart (Top drawing).
2. Push the sleeve of the female socket back and insert the male end of the connector. Release
the sleeve.
3. Push the socket until the female sleeve snaps forward to lock the fitting.
4. To disconnect the fitting, push the female sleeve back and pull the socket off the plug
(bottom drawing).
WARNING
1. Attach the coupling half (socket) to the gas
supply line in accordance with NFPA54/ANSI
Z223.1FUEL gas code.
2. Prior to inserting the plug, test the
connection for leaks following the leak test
instructions on page 12. After the leak test is
completed, rinse the connection with clean
water to remove any corrosive residue.
3. Do not use open flame to test for leaks.
7