Table of Contents
Advertisement
•
The descale programme is now terminated and the appliance is ready to
make coffee again.
NOTE: if the descaling cycle is interrupted before completion, the appliance
continues to display the descale message and the programme must be start-
ed again from the beginning. Empty the water tank, rinse, fill with clean water
and run off a cup of hot water.
IMPORTANT: FAILURE TO DESCALE THE APPLIANCE REGULARLY INVALIDATES
THE GUARANTEE.
16.4 Changing coffee temperature
To change the temperature of the coffee, proceed as follows:
•
Press the MENU' button (the light over the button comes on) then press
the NEXT button repeatedly until the appliance displays:
•
Press the CHANGE button until the appliance displays the required cof-
fee temperature.
•
Press the OK button to confirm the temperature selected;
•
Press theMENU' button to exit programming mode or NEXT to change
other parameters.
16.5 Changing the length of time the appliance remains on
The appliance is factory preset to go off automatically one hour after the last
coffee has been made.
The number of hours the appliance remains on (max. 3) can be increased as
follows:
•
Press the MENU' button (the light over the button comes on) then press
the NEXT button repeatedly until the appliance displays: OFF AFTER 1
HOUR.
•
Press the CHANGE button to change the number of hours the appliance
remains on.
•
Press the OK button to confirm the value;
•
Press the MENU' button to exit programming mode or NEXT to
change other parameters.
16.6 Setting water hardness
The descale message is displayed after the appliance has been operated for a
factory set period of time calculated on the basis of the maximum quantity of
lime scale which may be contained in the water used.
If necessary, this period of operation can be extended, making descaling less
frequent, by programming the appliance based on the actual lime content in
the water used.
Proceed as follows:
•
remove the "Total Hardness Test" strip (enclosed on page 2) from its pack-
aging then dip it fully in the water for a few seconds. Remove it and wait
around 30 seconds (until it changes colour and a number of red dots are
formed);
•
Turn the appliance on by pressing the
•
Press the MENU' button then press the NEXT button repeatedly until
the appliance displays:
•
Press the CHANGE button repeatedly until the number coincides with
the number of red squares on the test strip (for example, if there are 3
HIGH TEMPERATURE.
button (fig. 6).
WATER HARDNESS 4
OPERATING INSTRUCTIONS
17
Hide quick links:
Advertisement
Table of Contents
