Table of Contents
Advertisement
Empty the grounds container and clean thoroughly, making sure all residues
deposited on the bottom are removed.
IMPORTANT: when removing the drip tray, the grounds container MUST be emptied,
even if it is not completely full. If this is not done, when next making coffee the
grounds in the container may exceed the maximum level and block the appliance.
TIP 8: while the appliance is running off coffee, never remove the water tank.
If it is removed, it will not be possible to make the coffee and the appliance
will display:
GROUND TOO FINE ADJUST MILL AND
INSERT WATER SPOUT AND PRESS OK
To turn the appliance on again, you must insert the water spout (fig. 4), press
the OK button and run off water from the spout for a few seconds.
When using the appliance for the first time, 4-5 cups of coffee
need to be made before the appliance starts to give satisfying
results.
If the appliance malfunctions, do not contact the service centre straight
away.
The problem can almost always be resolved by following the instructions indi-
cated in paragraphs 18 and 19.
If this is not the case, or for further explanations, contact the customer serv-
ice by calling the number listed on the enclosed guarantee leaflet. If your
country is not listed on the sheet, call the number indicated on the warranty.
7 CHANGING THE QUANTITY OF COFFEE IN THE
CUP
The appliance is factory preset to automatically deliver the following quanti-
ties of coffee:
-
short coffee (40 ml) (when the
-
normal coffee (80 ml) (when the
-
long coffee (120 ml) (when the
To change these quantities, proceed as follows:
-
press the button corresponding to the quantity you want to change (
or
) for at least 8 seconds then release until the message "PRO-
GRAM QUANTITY" is displayed and coffee is delivered;
-
when the coffee in the cup reaches the required level, press the same but-
ton again to memorise the new amount and to stop the flow of coffee.
The appliance is now re-programmed with the new settings and displays:
READY.
8 REGULATING THE COFFEE MILL
The coffee grinder is preset in the factory to prepare coffee correctly and
should not require regulating initially.
However, after making the first coffees, if you find that coffee delivery is either
too fast or too slow (in drips), the grinding coarseness regulator can be
adjusted (fig. 12).
Turning it 1 click (1 number) clockwise speeds up coffee delivery (without
drips).
button is pressed);
button is pressed);
button is pressed);
,
OPERATING INSTRUCTIONS
9
Hide quick links:
Advertisement
Table of Contents
