Rear And Side Panels - Icom IC-706MKIIG Instruction Manual

1
PANEL DESCRIPTION
I
ANT 1
w
q
GND
ANT 2
q
Connect this terminal to a ground to prevent electri-
cal shocks, TVI, BCI and other problems.
w
Accept a 50 Ω antenna with an PL-259 type plug.
• [ANT 1] is for connection to an HF/50 MHz antenna.
• [ANT 2] is for connection to 144 MHz antenna.
• These connectors are switched above or below 60 MHz.
e
6-pin min DIN jack to connect a TNC, etc. for packet
operation.
r
Enables connection to external equipment such as
a TNC for data communications, a linear amplifier or
an automatic antenna selector/tuner, etc.
• See page at right for socket information.
t
Connects an external terminal unit for RTTY (FSK)
operation.
• The keying polarity and mark/shift frequencies can be
selected in quick set mode (p. 48).
y
(p. 45)
Designed for use with a personal computer for
remote operation of transceiver functions.
u
Accepts the supplied microphone (connected in
parallel with the front panel's [MIC] connector).
• See pgs. 1 and 2 for microphone notes.
• See p. 8 for microphone connector information.
i
Accepts a paddle to activate the internal electronic
keyer.
• Selection between the internal electronic keyer and
5
straight key operation can be made in quick set mode.
(p. 49)
e r
(p. 9)
(p. 11)
(p. 12)
(p. 6)
(p. 35)
(p. 11)
(p. 33)
t y
u i
KEY
MIC
TUNER DC 13.8V
EXT SP
!1 !0 o
When connecting
a straight key
When connecting
a paddle
o
Accepts 13.8 V DC through the supplied DC power
cable.
!0
Accepts a 4–16 Ω speaker.
!1
Accepts the control cable from an optional AH-3
AUTOMATIC ANTENNA TUNER
!2
Adjusts the compression level.
• This control is available only when the speech compres-
sor is ON.
Recommended
level
Counterclockwise
decreases
!2 !3
COMP BEEP
GAIN /SIDE T
(⊕)
(dot)
(com)
(dash)
(p. 13)
Rear panel view
.
(p. 26)
Clockwise
increases
COMP BEEP
GAIN /SIDE T
(p. 12)
(p. 12)
HF