Cw Pitch Control; Cw Reverse Mode; Electronic Cw Keyer; Setting The Electronic Keyer - Icom IC-706MKIIG Instruction Manual

D
The received CW audio pitch and monitored CW
audio pitch can be adjusted to suit your preferences
(300 to 900 Hz) without changing the operating fre-
quency.
➀
Push [MODE] one or more times to select CW
mode.
➁
Select in quick set mode.
•Push [DISP] for 2 sec. then push [MENU] one or more
times.
D
The CWå (CW Reverse) mode receives CW signals
with a reverse side CW carrier point like that of LSB
and USB modes. Use this mode when interference
signals are near the desired signal and you want to
change the interference tone.
➀
Push [MODE] one or more times to select CW
mode.
➁
Push and hold to toggle between CW and CWå
modes.
• Check the interference tone.
D
The IC-706MKIIG has an electronic keyer. Both key-
ing speed and weight (the ratio of dot : space : dash)
can be set in quick set mode.
•
➀
Select CW mode with [MODE].
➁
Push [DISPLAY] for 2 sec. to enter quick set mode.
➂
Push [MENU] one or more times to select item
, then rotate the main dial to select
the paddle type.
• When "ud" is selected, the up/down switches on the
microphone can be used as a paddle.
➃
Push [MENU] two more times to select item
, then rotate the main dial to select the
desired weight.
• Key weight can be selected from 2.8 to 4.5.
• Check the selected ratio with the side tone function in
CW mode.
➄
Push [DISPLAY] momentarily to exit quick set mode.
Connect a CW paddle as at right to operate an elec-
tronic keyer from the front panel MIC connector.
• This function is available from the front panel mic
connector only.
• Be sure to select item "n," "r," "buG" or "oFF" in
in quick set mode. (p. 49)
• Connect straight key to "DOT" side.
QUICK SET MODE
➂
➃
• Receive audio tone response
inteference
QUICK SET MODE
KEYING WEIGHT EXAMPLE: morse code "K"
Weight setting:
1:1:3 (default)
Weight setting:
Adjusted
*SPACE and DOT length can be adjusted with "
CW
paddle
RECEIVE AND TRANSMIT
Rotate the main dial to set the desired pitch.
Push [DISPLAY] to exit quick set mode.
CW
(Normal) CW
MODE
600 Hz
BFO inteference
signal
DOT
DASH
(Fixed*)
Adjustable range SPACE (Fixed*)
" only.
DOT
3.9 kΩ ±5%
2.2 kΩ ±5%
DASH
4
This shows the default
setting for the CW pitch
control (600 Hz).
(Reverse) CWå
600 Hz
signal
BFO
DASH
front panel
MIC connector
➆
E
➁
MIC U/D
34