Icom IC-RX7 Instruction Manual page 16

2
PANEL DESCRIPTION
@0 !9
q
w
e
r
t y u
w CATEGORY INDICATOR (p. 52)
During scan mode, the programmed memory category is
displayed.
e MEMORY GROUP INDICATOR (p. 53)
During scan mode, the programmed memory group is
displayed.
8
!8 !7 !6 !5 !4 !3
i o
r FREQUENCY READOUT
Displays a variety of information, such as operating fre-
quency, memory names.
• The decimal point blinks during search.
t RECEIVING MODE INDICATOR (p. 19)
!2
Shows the selected receiving mode.
• FM, WFM and AM are available, depending on operating band.
• "u" appears when auto mode is selected for USA version.
!1
y S-METER
Shows the relative signal strength while receiving signals.
!0
u PRIORITY WATCH INDICATOR (pgs. 38, 39, 47)
Appears when priority watch is in use.
i SKIP INDICATOR
➥ " SKIP" appears when the selected memory channel is
set as a skip channel. (pgs. 46, 55)
➥ " PSKIP" blinks during skip search operation. (p. 36)
o AUTO WRITE SEARCH INDICATOR
Blinks during auto write search operation. (p. 34)
!0 MEMORY NUMBER INDICATOR
Shows the selected memory number. (pgs. 54, 55)
• This number is assigned to memory name and use this number
for memory management in each memory category.
Memory organization: Category u Group u Name u Channel
• This number is assigned to memory channel for basic search.
The basic search can be re-programmed by optional CS-RX7.
!1 STATUS INDICATOR
Shows the receiver's status such as "HOLD," "SCAN,"
"SEARCH" or "MEMORY."