I Setting The Silent Stand-By Condition - Icom IC-400PRO Instruction Manual

6
SELCALL OPERATION

I Setting the silent stand-by condition

The SelCall mute condition allows silent operation until you
are selcalled.
q While in Function mode, push [DUP] (CONT/SGL) and
select the single tone to activate the SelCall mute
('Inaudible' condition).
• Push [ O ] (Bank/Func) for 1 sec. to enter the transceiver into
Function mode.
• When the single tone is selected, "SGL" is displayed briefly, and
the under bar appears as below.
Push [DUP]
w Push [ O ] for 1 sec. to enter Set mode, and push for 1 sec.
again to return to Normal mode.
Push [ O ] for 1 sec.
21
e To monitor the channel;
Push [MONI] for 1 sec.
r To enable SelCall mute;
Appears
Push [MONI]
Normal mode
Push [MONI] (Moni(Audi)) for 1 sec. to release the SelCall
mute (audio is emitted; 'Audible' condition).
• " " appears.
When " " appears, push the key to mute the channel
(sets to 'Inaudible').
• " " disappears.
NOTE: The unmute condition ('Audible' condition) may
automatically return to the mute condition ('Inaudible' con-
dition) after a specified time period depending on the pre-
setting.
Appears