The Pc Share Indicator; The Rotary Switch; The Coax/Twinax Switch; Test Mode - Axis HP MIO User Manual

The PC SHARE Indicator

The Rotary Switch

The Coax/Twinax Switch

Test Mode

AXIS HP MIO User's Manual
Appendix A: The AXIS HP MIO Rear Panel
This indicator (yellow) is lit during a local PC or LAN printout. Host
printouts will be held waiting until the PC/LAN printout is
completed.
The ten-position rotary switch is used for setting the AXIS HP MIO
device address (this applies to 5250/Twinax mode only – the switch
should always be in zero position in 3270/Coax mode).
The switch is also used for accessing Test Mode functions.
This switch (CX/TX) configures the AXIS HP MIO hardware for
Coax or Twinax mode operation. It should be set prior to the
installation. Do not alter this switch when the printer is powered on or
connected to the IBM system.
The Test Mode is used for accessing internal AXIS HP MIO
functions. Entering Test Mode makes the AXIS HP MIO go off-line
towards all connected input sources, so you do not have to disconnect
any cables.
HP MIO
35