Hardware Installation - Axis HP MIO User Manual

HP MIO
Section 2: Getting Started

Hardware Installation

Before you begin the installation, you must set the rear panel Coax/Twinax
switch in the correct position. Use a flat screwdriver to set the switch in
CX position (shown to the left) for 3270/Coax mode, or TX position for
5250/Twinax mode.
The AXIS HP MIO board should be installed into the MIO
expansion slot at the rear of your HP printer. The guidelines below are
for the HP LaserJet 4p, but the installation procedure is similar for all
HP printers. If you have a printer other than the LaserJet 4+, consult
the printer manual on how to access the MIO slot.
You will need one Philips and one flat screwdriver for the installation.
Removing the cover plate (HP LaserJet 4+)
12 AXIS HP MIO User's Manual