Ipod ® Playback; Preparations - Denon AVR-1509 Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT>
<ON/STANDBY> <STATUS>
[Front]
[OFF]
[iPod]
[2]
[1]
[6], [7]
[8], [9]
[ENTER]
[uip]
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]

iPod ® Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W, sold separately).
BUTTON
The operation can also be performed using the buttons on the
<BUTTON>
remote control unit.
[BUTTON]
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.

Preparations

1
Make the necessary preparations.
q S et the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod's operating instructions.)
w Assign the control dock for iPod's input.
[Rear]
The input for the control dock for iPod is assigned to VCR by
default.
"System Setup" – "Input Setup" – "iPod Assign"
(vpage 21)
2
<SOURCE SELECT>
Either turn
[iPod]
select the input source assigned in step 1-w above.
[TUNING + –]
3
[SOURCE CONTROL 1]
Set
[MODE]
CONTROL 2]
to "iPod/NETWORK".
[uip]
(v page 38 "Remote Control Unit Operations")
[ENTER]
4
Press
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, "Remote" is displayed.
[Selectable mode]
Display location
Playable
files
Active
buttons
z 1 : When using an ASD-3N or ASD-3W control dock for iPod
z
2 : Video may not be output, depending on the combination of
ASD-1R or ASD-11R and iPod.
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" (vpage 28).
<ON/STANDBY>
• Press
the standby mode before disconnecting the iPod. Also switch the
input source to one to which "iPod Assign" is not assigned before
[iPod]
or press to
disconnecting the iPod.
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
the respective manual to operate.
[SOURCE
to "AUDIO" and
[MODE]
and hold it down for a 2 seconds or
Browse mode Remote mode
Main unit display iPod display
Audio file
S
Video file S z 1
Remote
control unit
S
(AVR-1509)
iPod
A
[OFF]
or and set the AVR-1509's power to
S
S z 2
S
S
.